Session Status

Due to inactivity, your session will end in approximately 2 minutes. Extend your session by clicking OK below.

Due to inactivity, your session has expired. Please sign in again to continue.

KYOCERA DuraForce PRO 2 - Add / Remove Fingerprint Recognition

2026-10-03 20:30:19.69

KYOCERA DuraForce PRO 2 - Add / Remove Fingerprint Recognition

Here's how to set up and manage fingerprint recognition to unlock your DuraForce PRO 2.
For the fingerprint scanner to operate, hands must be clean and moisture-free.
  2. From a Home screen, navigate:
    Apps icon Apps icon
    Settings
    Security
    .
  3. From the Device security section, tap
    Fingerprint
    .
  4. If presented, enter the current PIN, password, or pattern.
  5. Perform one of the following:
    • First Time Setup
      1. Read the disclaimer then tap
        CONTINUE
        .
      2. Select the backup screen lock method (PIN, pattern, password).
      3. Select a notifications option then tap
        Done
        .
      4. From the 'Get ready!' screen, read the disclaimer the tap
        NEXT
        .
      5. Place your finger on the sensor until it vibrates then lift and repeat this step until the process is complete.
      6. Enter a name for the fingerprint then tap
        DONE
    • Add More Fingerprints
      1. Tap
        Add fingerprint
        .
        Up to 4 fingerprints can be registered on the device.
      2. Place your finger on the sensor until it vibrates then lift and repeat this step until the process is complete.
      3. Tap 'Done' if finished or 'Add fingerprint' to continue adding fingerprints.
    • Remove Fingerprint(s)
      1. From the 'Manage fingerprints' section, next to the fingerprint to be removed, tap the
        Trashcan icon
         Trashcan Icon (on the right).
      2. Tap
        YES, REMOVE
        .