Session Status

Due to inactivity, your session will end in approximately 2 minutes. Extend your session by clicking OK below.

Due to inactivity, your session has expired. Please sign in again to continue.

SHARP ROUVO V - Factory Data Reset (Powered Off)

2026-10-13 15:53:29.108

SHARP ROUVO V - Factory Data Reset (Powered Off)

Here's how to factory / hard reset your ROUVO V if the screen freezes or call, app, audio or sync issues occur and the device won’t start up.
  • Perform a factory data reset only if necessary as it removes your Google™ account and all data including system data, app data and media.
  • For devices with Android™ Device Protection turned on, it's imperative Google sign-in credentials are known prior to completing a factory reset with the device powered off. If credentials are unknown, do one of the following:
  • If a pattern, PIN, etc. is or has ever been set up on the device, Google account sign-in is required during initial setup.
  1. Ensure the device is powered off.
    If the device is responsive and can be powered on, the preferred reset method should be performed.
  2. Press and hold the
    Volume up button
     on the right edge of the device.
  3. While continuing to hold volume up, press and hold the
    Power button
     until the 'Select Boot Mode' screen appears.
  4. Using the 'Volume up' button, select
    Recovery
     from the Boot Mode menu. Tap the Volume down button to confirm choice.
  5. If presented with an image of a broken Android with 'No Command' shown on the screen, press and hold the
    Power button
    . Press the
    Volume Up button
     once then release the
    Power button
    .
  6. From the Android Recovery screen, select
    Wipe data/factory reset
    .
    Utilize the volume buttons to cycle through the available options and the side button to select.
  7. Select
    Factory data reset
    .
    Allow several seconds for the factory data reset to complete.
  8. Select
    Reboot system now
    .
    Allow several minutes for the reboot process to complete.
    If applicable, set up your device.