Session status messages
Session Status
Due to inactivity, your session will end in approximately 2 minutes. Extend your session by clicking OK below. Due to inactivity, your session has expired. Please sign in again to continue.

Session Status

Due to inactivity, your session will end in approximately 2 minutes. Extend your session by clicking OK below.

Due to inactivity, your session has expired. Please sign in again to continue.

LED Status Indicators - Arlo Go

View this info for explanations of status LEDs on your Arlo Go camera.

	Solid blue : The camera is registered and is connected to the mobile network.
	Very slow blinking blue : The camera is powering on.
	Slow blinking blue : The camera is ready to scan the QR code.
	Blinking blue : The camera is scanning the QR code.
	Fast blinking blue : The camera is connected to the cloud. During charging, blinking for three seconds indicates that charging started and blinking for two seconds indicates that charging is complete.
	Blinking blue and purple : The camera is connecting to the network and the cloud.
	Solid amber: No SIM card is inserted or the SIM card is damaged. During a sync, the battery charge is low. During the motion detection test, motion is detected.
	Blinking amber : Mobile network coverage is not available.
	Slow blinking amber : The battery level is low.
	Double blinking amber : The battery level is so low that it is critical.
	Blinking amber and purple : The SD card type is invalid.
	Blinking blue and amber : The camera is receiving a firmware upgrade.
	Fast blinking amber : The camera is connected to the cellular network but it cannot connect to the cloud. During a QR code scan, the scan failed. During battery charging, the charge failed.