Session Status

Due to inactivity, your session will end in approximately 2 minutes. Extend your session by clicking OK below.

Due to inactivity, your session has expired. Please sign in again to continue.

5G MiFi ® M1000 - MAC Filtering

2026-10-12 17:04:10.346

5G MiFi® M1000 - MAC Filtering

Here's how to control MAC address access for your 5G MiFi M1000.
  • MAC Filter is an advanced feature. Contact your local IT admin prior to altering this setting.
  • If turned on, only the devices added to the MAC address filter list can access the MiFi's Primary Wi-Fi network.
  • This MAC filter has no effect on the guest Wi-Fi network or USB devices.
  2. From the Settings section, click the
    Navigation arrow
     Navigation arrow (lower-right) to open the Settings page.
  3. Click the Advanced tab, review the warning then click
    Continue
    .
  4. Click
    MAC Filter
     (located below the Advanced tab, to the right).
  5. To add a device to the list, do the following:
    By default, any device that has previously connected to the jetpack already appears in the list.
    1. Click
      Add new device
       (lower-left).
    2. Configure/enter the following:
      • Name
      • MAC Address
  6. Click
    Save Changes
     (lower-right).
  7. To turn on MAC filtering, do the following:
    1. Select (check) the MAC Address Filter option located to the right of the corresponding device(s).
    2. Click
      Save Changes
       (lower-right).
    3. Tap the
      MAC Filter switch
       to turn on Switch on.
    4. Tap
      Confirm
      .