Due to inactivity, your session will end in approximately 2 minutes. Extend your session by clicking OK below.

Due to inactivity, your session has expired. Please sign in again to continue.

2025-05-16 02:42:15.375

Inseego MiFi 2100 5G UW - Insert / Remove Battery

Here's how to insert / remove the battery for your MiFi 2100 5G UW.
Use only approved batteries and chargers with your device. The warranty doesn't cover damage caused by non-approved batteries and/or chargers.
  1. Ensure your Inseego MiFi® 2100 5G UW is powered off and not connected to any device or power source.
  2. Remove the battery cover.
    Using the provided notch (on the left side of the device, display facing down), carefully lift then detach the cover. Set the cover aside.
    Remove cover
    +
  3. Do one of the following:
    • Insert Battery
      Ensure the connectors on the battery align with the connectors on the device.
      Insert battery
    • Remove Battery
      Insert your finger into the battery removal divot and lift the battery out of the battery compartment.
      Remove battery
  4. Replace the battery cover.
    Set it on the device where the notches align then press on the cover until it clicks into place and is flat across the entire bottom surface.
    Replace cover