Session Status

Due to inactivity, your session will end in approximately 2 minutes. Extend your session by clicking OK below.

Due to inactivity, your session has expired. Please sign in again to continue.

Orbic Speed 5G - Restore Settings to Factory Defaults

2026-10-05 10:55:58.062

Orbic Speed 5G - Restore Settings to Factory Defaults

If your Orbic Speed 5G powers off, crashes/resets, freezes or runs slowly, view this info.
Restore Settings to Factory Defaults on your Orbic® Speed 5G™ only if necessary as it removes all modified settings including Network Name (SSID), Wi-Fi / admin password, etc.

Via Device

The Master Reset button is in a small hole located on the bottom of the device, underneath the battery cover. Pressing this button returns the device to factory settings.
  1. Remove the battery cover.
    Insert your fingers into the battery cover removal notch at the left edge of the battery cover then lift and remove the battery cover. Set the cover aside.
    Battery cover removal
  2. With the back cover removed, locate the
    Reset button
    .
    Reset button
  3. Press and hold the
    Reset button
     with your finger or use the tip of a pencil or pen.
    Hold down for approximately 5 seconds or until the display shows 'Resetting'.
  4. Replace the battery cover.
    Ensure the notches align then press on the cover until it clicks into place and is flat across the entire bottom surface.
    Replace battery cover

Via Admin Web Interface

  2. From the top menu, click
    Configuration
    .
    Configuration
  3. From the left menu, navigate:
    Settings
    Restore and Restart tab
    .
  4. From the 'Restore to Factory Defaults' screen, click
    Restore factory defaults
     then follow the prompts.
    Reset