Due to inactivity, your session will end in approximately 2 minutes. Extend your session by clicking OK below.

Due to inactivity, your session has expired. Please sign in again to continue.

KYOCERA DuraForce PRO 3 - Insert / Remove Battery

2025-06-17 02:25:39.712
Here's how to insert / remove the battery for your DuraForce PRO 3.
Expand All
  1. Ensure the device is powered off.
  2. Using a coin, rotate the back cover screw on the back of the phone counter-clockwise several times to loosen it.
    Unlock back cover
  3. Insert your fingernail into the notch at the bottom of the back cover and lift the cover.
    Lift back cover
  4. Unlock the battery latch by sliding it in the direction indicated by the arrow in the picture below.
    Unlock battery latch
  5. Insert the battery, making sure to align the gold contacts. Press down gently to secure the battery.
    Insert battery
  6. Lock the battery latch by sliding it in the direction indicated by the arrow in the picture below.
    Insert battery
  7. Insert the top edge of the back cover into place first before pressing the rest of the cover down.
    The back cover won't close properly unless the battery latch is in the locked position.
    Insert back cover
  8. Press all around the edges of the back cover as shown below, starting at the top and working your way down along each side, as shown below. Make sure all the tabs are secure and there are no gaps between the cover and the phone.
    Press down to secure cover
  9. Using a coin, rotate the back cover screw to secure it. Don't over tighten.
    Tighten the screw to lock cover
  1. Ensure the device is powered off.
  2. Using a coin, rotate the back cover screw on the back of the phone counter-clockwise several times to loosen it.
    Unlock back cover
  3. Insert your fingernail into the notch at the bottom of the back cover and lift the cover.
    Lift back cover
  4. Unlock the battery latch by sliding it in the direction indicated by the arrow in the picture below.
    Unlock battery latch
  5. Hold the phone with one hand and tap it gently against your other hand to dislodge the battery.
    Remove battery
  6. Lock the battery latch by sliding it in the direction indicated by the arrow in the picture below.
    Insert battery
  7. Insert the top edge of the back cover into place first before pressing the rest of the cover down.
    The back cover won't close properly unless the battery latch is in the locked position.
    Insert back cover
  8. Press all around the edges of the back cover as shown below, starting at the top and working your way down along each side, as shown below. Make sure all the tabs are secure and there are no gaps between the cover and the phone.
    Press down to secure cover
  9. Using a coin, rotate the back cover screw to secure it. Don't over tighten.
    Tighten the screw to lock cover