Due to inactivity, your session will end in approximately 2 minutes. Extend your session by clicking OK below.

Due to inactivity, your session has expired. Please sign in again to continue.

2025-05-15 18:16:24.404

4G LTE Network Extender for Enterprise 2 - Install the GPS Extension Cable

Here's how to install the external antenna on your 4G LTE Network Extender for Enterprise 2.
The 4G LTE Network Extender for Enterprise is an advanced business solution that's not available for consumer use.
  • If a stable GPS signal isn't detected, follow the steps below to install the GPS antenna cable.
    A minimum of 4 satellites are required to provide a GPS location fix. Refer to LED Status Indicators to determine whether a GPS signal has been acquired during initial setup.
  • For best results, place the Network Extender in an elevated location near a south-facing window or a window with a clear view of the sky.
  • Refer to the Quick Start Guide for wall mount instructions.
  1. Ensure the Network Extender is powered off and unplugged from the power outlet.
  2. From the connection side of the Network Extender, attach the GPS antenna cable (indoor use only) to the GPS port (mini-coax).
    Don't force the cable into the mini-coax connector as doing so may damage it.
    GPS antenna mini-coax connecting to the GPS Port
  3. Place the GPS antenna in an elevated location then plug the Network Extender back into a wall outlet and allow the device to go through the setup process again.
    For best results, place the GPS antenna near a south-facing window or a window with a clear view of the sky, and with the 'GPS' letters facing up.
    If sufficient GPS signal still can't be acquired, test your Network Extender at a different location.