Due to inactivity, your session will end in approximately 2 minutes. Extend your session by clicking OK below.

Due to inactivity, your session has expired. Please sign in again to continue.

2025-05-15 02:30:38.025

4G LTE Network Extender for Enterprise 2 - Wired Connection - LMT Port

If you're having issues connecting Ethernet to your 4G LTE Network Extender for Enterprise 2, view this info.
The 4G LTE Network Extender for Enterprise 2 is an advanced business solution that's not available for consumer use.
  • The Network Extender is designed to be plug-and-play on most networks; the configuration console allows for custom functionality.
  • The PC must have Internet Explorer 9 or above to access the web Interface.
  • Configuration console links to external resources are not available while connected via the LMT port.
  1. From the connection side of the Network Extender, connect the supplied Ethernet cable from the Network Extender LMT Port to an available Ethernet port on the computer.
    Wired connection to LMT Port
  2. Open Network Connections.
    Navigate:
    Start
     > (Settings if present) >
    Control Panel
     >
    View network status and tasks
     (Network and Sharing Center if present) >
    Manage network connections
    .
    Alternatively Navigate:
    Start
     >
    Run
    , enter "CMD" then press the
    Enter key
     > Enter "NCPA.CPL" then press
    Enter
    .
    Alternatively Navigate:
    Start
     >
    Run
    , enter "CMD" then press the
    Enter key
     > Enter "CONTROL NETCONNECTIONS" then press
    Enter
    .
  3. Right-click
    Local Area Connection
     then click
    Properties
    .
    Alternatively, right-click on
    Ethernet
     connection then click
    Properties
    .
  4. From the General tab, ensure 'Internet Protocol Version 4 (TCP / IPv4)' is selected then click
    Properties
    .
  5. Ensure "Use the following IP address" is selected, enter the following settings then click
    OK
    .
    IP Address
    192.168.32.28
    Subnet mask
    255.255.255.0
    Typically the setting must be changed back to "Obtain an IP address automatically" to get back onto your company's network or any network that requires DHCP.
    If testing fails, try replacing your ethernet cable and attempt to test the connection again.
  6. Launch a web browser then navigate to
    https://192.168.32.27
    .
    If presented with a security certificate message, click
    Continue to this website
     to access the configuration console.
  7. From the Network Extender configuration console, click
    Sign In
     Sign in/out icon (upper-right).
  8. Enter the admin password then click
    Sign In
    .
    Default password: enterpriseFemt0 (zero at end) and is case sensitive.