4G LTE Network Extender for Enterprise 2 - Connect and Power On the Device

If you're having initial setup issues on your 4G LTE Network Extender for Enterprise 2, view this info.

The 4G LTE Network Extender for Enterprise 2 is an advanced business solution that's not available for consumer use.

Don't connect the AC Adapter (Power Supply) into a Power Outlet until instructed. Doing so may cause an electrical short or power surge to the Network Extender.

The first time the Network Extender is set up it will be usable within 15 minutes and may take up to 2 hours before all features are fully functional. If the GPS LED is still red after one hour, relocate the GPS antenna to receive a stronger signal. Refer to Install the GPS Extension Cable for assistance.

From the connection side of the Network Extender, attach the supplied Ethernet cable from the network extender B/H Port to an available LAN/Ethernet port on the router/modem.

Connect the provided power supply to the Network Extender and ensure the power supply is connected to the power cord then connect it to an available power outlet.

The use of a surge protector is recommended.

Connecting the power supply to a power outlet and PWR port

Verify that the LED Status Indicators are illuminated correctly.

Allow up to two hours for the Network Extender to complete initial startup.

Refer to Meaning of LED Status Indicators for assistance.

Layer_4 Created with Sketch.

4G LTE Network Extender for Enterprise 2 - Connect and Power On the Device