Session Status

Due to inactivity, your session will end in approximately 2 minutes. Extend your session by clicking OK below.

Due to inactivity, your session has expired. Please sign in again to continue.

Inseego MiFi X PRO 5G UW - LAN Settings

2026-10-12 17:09:25.962

Inseego MiFi X PRO 5G UW - LAN Settings

Here's how to configure advanced LAN settings for your Inseego MiFi X PRO 5G UW.
View this info to configure advanced LAN settings (e.g., IP address, Subnet mask, DHCP address range, etc.) for your Inseego MiFi® X PRO 5G UW.
Changing advanced settings may be harmful to the stability, performance, and security of the MiFi. Contact your local IT admin prior to altering any of these settings.
  2. From the Settings section, click the
    Navigation arrow
     Navigation arrow (lower-right) to open the Settings page.
  3. Click the
    Advanced tab
     , review the warning then click
    Continue
    .
  4. Click
    LAN
     (below the Advanced tab).
  5. From the IP Passthrough section, click
    Turn on IP Passthrough
     to turn on or off.
    On when a checkmark is present.
    1. When IP Passthrough is enabled, click the
      IPPT Interface dropdown
       then select 'Ethernet' or 'USB'.
    2. In the MAC Address field, enter the MAC Address of the device connected for IP Passthrough.
  6. From the IPv4 section, enter the desired info into the following fields:
    • IP address
    • Subnet mask
    • Turn on DHCP server
      On when a check mark is present.
    • DHCP lease time
    • Start DHCP address range at
    • End DHCP address range at
  7. From the IPv6 section, click
    Turn on IPv6
     to turn on or off.
    On when a checkmark is present.
  8. Click
    Save Changes
    .