Session Status

Due to inactivity, your session will end in approximately 2 minutes. Extend your session by clicking OK below.

Due to inactivity, your session has expired. Please sign in again to continue.

Wi-Fi Extender (E3200)
Set Up Device / Pair

2026-10-13 16:49:39.395

Wi-Fi Extender (E3200)
Set Up Device / Pair

Expand your home network coverage. Check out this guide to configure and connect your Wi-Fi Extender E3200.

Wireless (WPS) Pairing

  1. Plug the Wi-Fi Extender into a power outlet next to the Verizon Internet Gateway and wait for a solid yellow light.
    Plug in Wi-Fi Extender
  2. Press and hold the
    Unified button
     (pair button) on the Wi-Fi Extender E3200 for 3 seconds, then the
    Pair button
     on the Verizon Internet Gateway (within 2 minutes).
    Both devices blink blue while pairing.
    If there is an error during the pairing process, the Status LED slowly flashes red for 2 minutes after the error happens.
    Once a solid white or blinking yellow light appears on the Wi-Fi Extender E3200, it’s paired.
    Press pair button
  3. Unplug the Wi-Fi Extender from the power outlet, move it between the internet gateway and the weak Wi-Fi coverage area, then plug into a power outlet.
    If you see a fast-blinking yellow light move the extender further away from the internet gateway.
    If you see a slow-blinking yellow light move the extender closer to the internet gateway.
  4. Once the LED indicator turns solid white, your setup is complete.

Wired (Ethernet) Pairing

  1. Connect the Wi-Fi Extender to the router via the Ethernet cable.
  2. Plug the Wi-Fi Extender into a power outlet and wait for a solid yellow light.
    Both devices blink blue while pairing.
    If there is an error during the pairing process, the Status LED slowly flashes red for 2 minutes after the error happens.
    Once a solid white or blinking yellow light is seen on the Wi-Fi Extender E3200, it’s paired.
    Press pair button
  3. Unplug the Wi-Fi Extender from the power outlet, move it between the internet gateway and the weak Wi-Fi coverage area, then plug into a power outlet.
    If a fast-blinking yellow light is seen, move the extender further away from the internet gateway.
    If a slow-blinking yellow light is seen, move the extender closer to the internet gateway.
  4. Once the LED indicator turns solid white, your setup is complete.

View LED Status Indicators