Due to inactivity, your session will end in approximately 2 minutes. Extend your session by clicking OK below. Due to inactivity, your session has expired. Please sign in again to continue. |
How to connect your audio amplifier device to your Fios remote control using remote codes
Your Fios remote control and set-top box are programmed when you receive them. Once your set-top box and TV are connected, use your Fios remote to program it to your TV.
With your TV turned on, press:
- Menu > Customer Support > Top Support Tools > Program Fios Remote, press OK and follow the prompts on your TV screen
Note: DRC800 Fios remote must be programmed using the steps in the user guide. Use the same steps if you need to reprogram your remotes.
To buy a new remote visit the Fios Equipment & Accessories Store.
Find your audio amplifier remote control code(s) listed in alphabetical order by manufacturer below. The following codes can only be used with the Phillips P144 and Motorola DRC800 remote controls.
Manufacturer | Codes |
---|---|
JBL |
3781 |
JVC |
0358 |
Left Coast |
0919 |
Lexicon |
3784 |
Marantz |
0919, 3778 |
McIntosh |
3785 |
Manufacturer | Codes |
---|---|
Optimus |
0327 |
Parasound |
3782 |
Philips |
0919 |
Pioneer |
0040, 0327, 3775 |
Polk Audio |
0919 |
RCA |
0327 |
You can download your user guide below for additional information on your remote control. Select your user guide below:
-
1.Turn on the device you want to program your remote to
-
2.Press and hold the appropriate device button and press OK
-
3.Release both buttons and the device buttons will blink twice
-
4.Enter the remote code for the device, the device button will blink three times.
-
5.Point the remote at the device and press the Power button, and your device should turn off. This confirms it is programmed!