Due to inactivity, your session will end in approximately 2 minutes. Extend your session by clicking OK below.

Due to inactivity, your session has expired. Please sign in again to continue.

2025-05-17 12:53:51.179

moto g stylus - Add / Remove Fingerprint Recognition

Here's how to set up and manage fingerprint recognition to unlock your moto g stylus.
For the fingerprint scanner to operate, hands must be clean and moisture-free.
  2. From a Home screen, navigate:
    Settings Settings icon
    Security
    Fingerprint
    .
  3. Enter the current PIN, password or pattern.
  4. Perform one of the following:
    • First Time Setup
      1. From the 'Unlock with your fingerprint' screen, tap
        Set up
        .
      2. Place your finger on the
        sensor
         (back of the phone) until it vibrates then lift it and repeat this step until the process is complete.
      3. Tap
        Done
        (at the bottom).
    • Add More Fingerprints
      1. Tap
        Add fingerprint
        .
        Up to 5 fingerprints can be registered on the device.
      2. Place your finger on the
        sensor
         until it vibrates then lift it and repeat this step until the process is complete.
      3. Tap
        Done
        .
    • Remove Fingerprint(s)
      1. Tap the
        Delete icon
         Trash can icon to the right of the fingerprint you want to remove then tap
        Delete
        .
      2. If presented with 'Remove all fingerprints?', tap
        Yes, remove
         if desired.