Due to inactivity, your session will end in approximately 2 minutes. Extend your session by clicking OK below.

Due to inactivity, your session has expired. Please sign in again to continue.

2025-05-17 01:15:35.171

KYOCERA DuraForce PRO 3 - Insert or Remove SD / Memory Card

Here's how to insert or remove an SD / memory card for your DuraForce PRO 3.
The DuraForce PRO 3supports microSD memory cards which can be purchased from any Verizon store or online.
  1. Ensure the phone is powered off.
  3. Locate the SIM / microSD card slot inside the battery compartment then pull the card tray out of the slot.
    Remove SIM / SD card tray
  4. Do one of the following:
    • Insert the SD / Memory Card
      1. Put the tray onto a flat surface and place an SD / memory card into the tray. Ensure the gold contacts are facing down as shown. Insert the SD / memory card into the tray with gold contacts facing down.
        Insert SIM card into tray with gold contacts facing down
    • Remove the SD / Memory Card
      1. To remove the SD / memory card, gently push up on the card from underneath the tray.
        Remove SIM Card
  5. Insert the tray into the SIM / microSD card slot. If inserting the SD / memory card, be careful not to let the card slide out. Then gently push the tray back into the slot until it fits into place.
    Insert SIM tray
  6. Place the battery back into its compartment, lock it in place by sliding the battery latch then replace the back cover. If necessary, refer to Insert / Remove Battery for assistance.